5 Series E60 M5 (S85) SAL
67 65 010
Removing and installing or replacing drive
unit for roller sun blind
Necessary preliminary tasks:
•
Remove panel for parcel shelf.
Important!
Do not power up the drive unit if it is not completely connected
to the roller sun blind.
If the roller sun blind is not completely rolled up, there is
spring pressure on the drive linkage.
In this case, maintain the roller sun blind under pretension and
carefully lever out the linkage. Now allow the roller sun blind to roll
up slowly.
Remove locking clips (1) towards bottom.
Installation:
Replace locking clips (1).
Lever out drive linkage (2) on left and right.
Release screw (3) and remove complete drive linkage (4)
towards top.
Installation:
Make sure drive linkage (1) is correctly positioned on drive
shaft (2).
Drive linkage (1) can only rest in one single position on the drive
shaft (2).
RA Removing and installing or replacing drive unit for roller sun blind
BMW AG - TIS
23.02.2013 09:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
