5 Series E60 M5 (S85) SAL
The KBM controls the interior lighting. In the event of an accident exceeding a certain severity (crash signal from
crash safety module) the interior light is automatically switched on and the rear central locking is unlocked.
-
JBE: Junction box electronics
> E70, E93
The JBE is connected to the crash safety module via the K-CAN.
The JBE is the executing control unit for the central locking system. (The CAS control unit is the master control
unit for the central locking system. )
-
LM: Light module
> E60, E61, E63, E64
The lights module is connected to the crash safety module via the K-CAN. In the event of an accident exceeding
a certain severity (crash signal from crash safety module) the light module will switch the hazard warning lights
on.
-
LSZ: Light switch cluster
> E85
The light switch cluster is connected to the crash safety module via the K-bus. In the event of an accident
exceeding a certain severity (crash signal from crash safety module) the light switch cluster will switch the
hazard warning lights on.
-
FRM: Footwell module
> E70, E93
The footwell module is connected to the crash safety module via the K-CAN. In the event of an accident
exceeding a certain severity (crash signal from crash safety module) the footwell module will switch the hazard
warning lights on.
-
SMFA and SMBF: Driver's seat module and front passenger's seat module
> E64, E93
Seats with three-point seat belt integrated in the backrest are installed in the cabriolet. If the seat backrests are
not locked correctly, in the event of an accident there is the danger that the occupants move forward with the
backrests with no restraint.
The seat modules monitor the seat backrest to ensure they are locked correctly. Hall sensors are installed in the
seat backrests for this purpose.
>
E64
The seat modules send messages on the K-bus to the centre console switch cluster (SZM) when the seat
backrests are not locked correctly. The SZM is the data interface (= gateway) to the K-CAN. The SZM
processes the message (check control message).
>
E93
If the backrests are not correctly locked, the seat modules will emit messages on the K-CAN.
The check control messages are shown in the instrument cluster and in the central information display.
The check control message is triggered as follows:
•
The seat belt indicator lamp in the instrument cluster comes on (visual seat belt warning).
•
The check control symbol is shown in the LCD display.
•
The check control messages relating to the check control symbol are shown in the Central Information
Display (CID).
The crash safety module controls the following components:
-
Triggering circuit for the airbags
With the maximum amount of equipment, the safety system consists of the following triggering circuits:
SBT Crash safety (ACSM) E60, E61, E63, E64, E70, E85, E93
BMW AG - TIS
23.02.2013 20:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
