5 Series E61 520d (M47T2) TOUR
13 62 560
Removing and installing/replacing air-mass
flow sensor (M47T2, M57T2)
Necessary preliminary tasks:
•
Read fault memory of DDE control unit.
•
Switch off ignition
•
Remove intake manifold
Unlock plug connection on air-mass flow sensor and disconnect.
Release screws (1) and remove air-mass sensor.
Tightening torque 13 62 7AZ.
Note:
Check stored fault messages.
Now clear the fault memory.
RA Removing and installing/replacing air-mass flow sensor (M47T2, M57T2)
BMW AG - TIS
25.01.2013 19:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -