5 Series E61 520d (M47T2) TOUR
Important!
Pay attention to power steering hoses and lines when
lowering and raising. Hoses/lines must not be
kinked/tensioned/bent!
When lowering and raising, make sure the cover for the
relevant tension strut rubber mount is free to move.
Release screws (1, 2).
Installation:
Check threads for damage; if necessary, repair with Helicoil thread
inserts.
Tighten down screws (1) and then screws (2).
Tightening torque 31 10 1AZ
.
Important!
Risk of damage!
The following operation must be carried out during lowering:
-
N54 with automatic transmission: Release screws (1)
and remove bracket (2) for transmission oil cooler lines
from front axle carrier
Lower front axle carrier 100 mm.
After installation:
•
Version with Dynamic Drive:
-
Fill and bleed hydraulic system
-
Check pipe connections for leaks
•
Carry out steering angle sensor adjustment/adjustment for
active steering
•
Carry out initial Dynamic Drive operation
RA Lowering/raising front axle carrier
BMW AG - TIS
25.01.2013 21:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -