5 Series E61 520i (N43) TOUR
Release banjo bolt (1) and detach pressure line (2) from vane
pump.
Installation:
Replace all sealing rings.
Make sure pressure line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 3AZ
.
Release hose clamp (4) and detach suction line (3) from vane
pump.
Installation:
Markings (5) on suction line and vane pump connection must
match up.
Release screws (1, 2) and remove vane pump towards rear.
Installation:
Refit spacer (3).
Make sure spacer (3) is correctly seated in vane pump bracket.
Tightening torque 32 41 1AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
RA Removing and installing (replacing) vane pump for power steering (N43)
BMW AG - TIS
03.02.2013 18:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
