5 Series E61 523i (N52) TOUR
Release screws (1).
Tightening torque: 11 37 1AZ
.
Set down guide blocks (2) in special tool 11 4 481 in neat
order.
Installation:
Mixing up the guide blocks may cause the engine to demonstrate
idle fluctuations.
This will result in maladjustment of uniform distribution.
Installation:
Contact surfaces (1) must be clean and oil-free.
Clean if necessary.
Lift out intermediate levers (2).
Intermediate levers (2) set out in special tool 11 4 481 in order.
Installation:
Mixing up the intermediate levers may cause the engine to
demonstrate rpm fluctuations.
Installation:
Contact surfaces (1) must be clean and oil-free.
Clean if necessary.
All intermediate levers (1) are classified.
Reinstall intermediate levers which have already been used in the
same positions.
RA Removing and installing/replacing intermediate levers (N52)
BMW AG - TIS
05.02.2013 01:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
