5 Series E61 523i (N52) TOUR
12 51 001
Replacing wiring harness section for engine
(N52)
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Follow instructions for disconnecting and connecting battery
Disconnect battery negative lead from battery and lay to one
side
•
Remove fresh air duct
•
Remove intake air manifold
•
Remove DME control unit
E60, E61, E63, E64 only:
Unlock plug on control unit and disconnect.
Unlock tab (1), pull contact carrier (2) in direction of arrow out of
housing.
E60, E61, E63, E64 only:
Unlock slide (2) in bore holes (1) and pull out of housing.
Unlock tab (3), pull contact carrier (4) in direction of arrow out of
housing.
Unlock and disconnect all plug connections of engine wiring
harness section in electronics box.
RA Replacing wiring harness section for engine (N52)
BMW AG - TIS
05.02.2013 02:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -