5 Series E61 523i (N52) TOUR
Release screws.
Installation:
ZNS bolts and nuts must be replaced.
Replace self-locking nuts.
Important!
Only M57:
The bolt without washer may only be tightened by means of
the nut.
The bolt with rolled-on washer which has ribbed teeth facing
the support side must be tightened by means of the bolt.
Observe different tightening torques.
Tightening torque, 26 11 1AZ.
Release bolts and replace.
Using a screwdriver, press constant velocity joint off drive flange
at disassembly grooves.
Important!
Do not let propeller shaft fall into joints.
Joints and rubber sleeve can be damaged on constant-
velocity joint.
RA Removing and installing complete propeller shaft (constant-velocity joint)
BMW AG - TIS
05.02.2013 03:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
