5 Series E61 523i (N52) TOUR
Installation:
Replace ribbon cable from ignition starter switch to CAS control
unit and secure with adhesive tape.
Mark installation position of steering column.
Unfasten screws.
Tightening torque 32 31 6AZ
.
Mark installation position of steering column (2).
Release screws (1).
Remove steering column (2) towards rear.
Installation:
Insert steering column (2) through instrument panel and insert
screws (1).
Align steering column (2) by way of markings and tighten down
screws (1).
Tightening torque 32 31 6AZ
.
Replacement:
•
Remove ignition starter switch
•
Remove ring antenna
•
Remove lock cylinder
After installation:
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
•
Perform function check:
I)
Check for ease of movement in overall adjustment range
of steering column to adjoining components/wires
II)
Turn steering wheel in both directions to full lock. The
airbag warning lamp must not light up in the process.
•
Check directional stability of car
RA Removing and installing/replacing steering column
BMW AG - TIS
05.02.2013 04:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
