5 Series E61 523i (N52) TOUR
Drawing in rubber mount (view from below):
If necessary, apply a marking to special tool 33 4 272 .
Coat rubber mount with Circo Light anti-friction agent (refer to
BMW Parts Service) and insert in special tool 33 4 272 .
Important!
Arrows or stops (2) of inner sleeve must point in vehicle
longitudinal direction (F) when rubber mount is installed. A
maximum deviation (A) of
±
7
°
must be observed.
Align rubber mount using arrows or stops (2) to marking on
special tool 33 4 272 .
Assemble special tools 33 4 154 , 33 4 155 , 33 4 271 ,
33 4 272 as illustrated.
Check installation position of rubber mount to marking on special
tool 33 4 272 , correct if necessary.
Align special tool 33 4 272 using marking to vehicle longitudinal
direction, fit on rear axle carrier and screw on special tool
33 4 153 .
Check installation position of special tools 33 4 272 and
33 4 153 , correct if necessary.
Draw in rubber mount by turning special tool 33 4 155 .
After installation:
•
Activate and fill air suspension system
RA Replacing all rubber mounts for rear axle carrier
BMW AG - TIS
05.02.2013 05:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
