5 Series E61 523i (N52) TOUR
Assembly: Pressure lines to oscillating motor
Note:
Before the stabilizer is installed, the pressure lines must be
aligned to the oscillating motor and secured using banjo bolts.
Installation:
1.
Screw nuts into stabilizer, do not tighten down
2.
Attach special tool 33 0 170 to pressure lines (the side of
the special tool illustrated must point in the direction of the
oscillating motor)
3.
Tighten down nuts
Tightening torque 37 14 18AZ
.
4.
Remove special tool
Replacement:
Remove rubber mount on both sides from stabilizer.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing/replacing rear active stabilizer
BMW AG - TIS
05.02.2013 08:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
