5 Series E61 523i (N52) TOUR
Topping up fluid in hydraulic unit:
Remove hydraulic unit.
Release nuts (1) and remove hydraulic unit from bracket (2).
Tightening torque 51 24 4AZ
.
Important!
Hose clamp (2) must not be released because turning the
fluid tank (1) will leave the fluid level marking in the wrong
position.
Set hydraulic unit (1) on a level surface with fluid tank (2) facing
upwards.
Open seal plug unit (3) and replenish hydraulic fluid.
Do not cover the opening in the process as the system is
simultaneously bled via the filler opening.
Installation:
Replace seal plug unit. Tightening torque 51 24 2AZ
.
Check fluid level.
RA Instructions for automatic rear lid actuation (electrohydraulic/fully automatic)
BMW AG - TIS
05.02.2013 10:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
