5 Series E61 523i (N52) TOUR
72 11 050
Removing and installing/replacing front belt
anchor fitting tensioner (driver seat only)
Warning!
Read and comply with safety regulations for handling airbag
modules and pyrotechnical belt tensioners.
Improper handling can lead to triggering of the pyrotechnical
seat belt tensioner or side airbag, resulting in injuries.
Switch off ignition!
Necessary preliminary tasks:
•
Remove upper rail trim
Disconnect cable straps.
Installation:
Replace faulty cable straps.
Plug connection must not be under tension.
Unfasten plug connection (1) and disconnect.
Release screw (2).
Tightening torque 72 11 08AZ
.
Remove anchor fitting tensioner (3).
Installation:
Secure plug connection with felt strip against unlocking.
RA Removing and installing/replacing front belt anchor fitting tensioner (driver se
BMW AG - TIS
05.02.2013 17:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -