5 Series E61 523i (N52) TOUR
•
Switch to partially fresh air from air-recirculation/AUC/automatic air-recirculation mode
•
Switch from partially fresh air in air-recirculation/AUC/automatic air-recirculation mode to fresh air
•
Switch off variable evaporator control
•
Raise blower speed (max. 28 %)
•
Reduce airflow to footwell (by about 60 %)
•
Increase temperature setting (by max. 2.5
°
C)
Convertible program (E64 only)
The convertible program is activated in the factory. (this factory setting can be deactivated win the Car and Key
Memory)
Switch-on conditions:
•
Terminal 15 ON
•
Convertible top open
The convertible program comprises the following functions:
•
The condensation sensor is switched off
•
The blower speed increases with increasing road speed
•
Air distribution is switched to the upper body and head, airflow to the footwell is throttled
•
Dynamic pressure compensation is changed, i.e. as road speed increases, the volume of air fed into the
vehicle through the fresh air grille increases.
•
Solar sensor control variables are changed
When the convertible top is open, the solar sensor evaluates the surrounding brightness (darkness to
intense sunshine) more strongly. For this reason, the solar sensor has a stronger effect on the IHKA
controls when the convertible top is open.
In the convertible program, the blower speed can be changed manually at the IHKA controls. The automatic flap
control remains active (no change to flap position).
If the convertible program is active and the flap positions are changed with the CID and controller, the
convertible program will be deactivated. This means that manual settings will be assumed, unchanged settings
will revert to those that the air-conditioning system had before the convertible top was closed.
The convertible program can be completely reactivated by pressing the AUTO button.
Independent ventilation function
The independent ventilation function is activated either via the Central Information Display (CID) or via Telestart
(through the Car Access System (CAS)). There are 2 ways of activating the system via the CID:
Direct operation or programming using the timer.
If the independent ventilation function is programmed via the timer, the independent ventilation function will only
be available at exterior temperatures above 15
°
C.
The battery's charge level is constantly monitored by the intelligent battery sensor throughout the independent
ventilation function. If the necessary charge level is not maintained, the IHKA control unit will deactivate the
independent ventilation function.
Independent heater (option 536)
The independent heating function is activated either via the Central Information Display (CID) or via Telestart
(through the Car Access System (CAS)). There are 2 ways of switching the system on via the CID:
Direct operation or programming using the timer.
Conditions required for switching the independent heater on:
•
Exterior temperature below 15
°
C (only applicable after programming with the timer)
SBT Integrated automatic heating / air-conditioning system (IHKA), Basic and High E6
BMW AG - TIS
06.02.2013 01:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -
