5 Series E61 525d (M57TU) TOUR
Mark severance cuts in accordance with specified measurements and cut.
Important!
Cut outer metal sheet only.
Measurement a = approx. 170 mm from roof edge.
Measurement b = approx. 120 mm from middle of lower lock striker screw point.
Measurement c = approx. 300 mm
Open weld joints in areas (1).
Installation information:
-
Apply window glass adhesive to cavity acoustic baffle (2).
-
Weld in reinforcement plates at severance cuts.
Note:
The following work step applies to the M5 only.
The connection area is partially glued on the M5!
Expose and detach wheel arch connection area.
Note:
The work step for the M5 ends here.
RA Replacing rear left side panel (partial replacement before longitudinal member c
BMW AG - TIS
11.02.2013 14:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -