5 Series E61 525xi (N52) TOUR
Important!
Conrod and conrod bearing cap are identified with pairing
letters (1) and must not be mixed up.
Mixing them up or incorrectly fitting the conrod bearing cap on
the big end will result in engine damage.
Apply a light coat of oil to crank pin.
Assemble conrod and crank pin.
Detach special tool 11 8 330 .
Fit bearing caps (2) so that pairing letters match up.
Install new conrod bolts (1).
Tightening torque: 11 24 1AZ
Adjust torsion angle of conrod with special tool 00 9 120 (see
illustration).
Tightening torque: 11 24 1AZ
RA Removing and installing/replacing all pistons (N52)
BMW AG - TIS
17.02.2013 18:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -