5 Series E61 525xi (N52) TOUR
12 51 100
Replacing wiring harness section for ignition
coil (N52)
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Follow instructions for disconnecting and connecting battery
Disconnect battery negative lead from battery and lay to one
side
•
Remove fresh air duct
•
Remove acoustic cover
•
E65: Remove centre of assembly compartment bulkhead.
Only: E60, E61, E63, E64
Unlock cover (1) with slide (3).
Unfasten screws (2).
Remove electronics box cover (1).
Only: E65
Release screw and remove holder (1).
Release screws and remove cover (2) from electronics box.
Release screws on seal (3).
RA Replacing wiring harness section for ignition coil (N52)
BMW AG - TIS
17.02.2013 19:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
