5 Series E61 525xi (N52) TOUR
Release banjo bolts (1, 4).
Remove brackets for pressure and return lines from front axle
carrier.
Disconnect pressure line (2) and return line (3) from power
steering gear.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 32 41 3AZ
.
Release screws (1) and remove nuts.
Installation:
Replace screws and self-locking nuts.
Tightening torque 32 00 1AZ
.
Important!
Pay attention to power steering hoses and lines when
lowering. Hoses/lines must not be tensioned/bent/kinked!
When lowering and raising, make sure the cover for the
relevant tension strut rubber mount is free to move.
Press front axle carrier forwards to guide power steering gear past
output shaft.
Lower front axle carrier further.
Important!
Pay attention to vacuum hose of electric switchover valve.
Slide power steering gear towards rear up to stop, rotate and
remove at side.
RA Removing and installing/replacing power steering gear (AWD)
BMW AG - TIS
18.02.2013 01:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
