5 Series E61 525xi (N52) TOUR
Release screws (1) on left and right and remove panel (2)
outwards.
Cut out carpet (4) at marked cutting edges (3) on left and right.
Important!
If there are no marked cutting edges (3), align cuts as far as
possible in direction of middle of vehicle. This ensures that the
cutting edges are covered by the storage
compartment/instrument panel.
Pay attention to cables when cutting (risk of damage).
Remove carpet (4) toward rear/top and if necessary feed out
cable.
Replacement:
Cut out carpet at marked cutting edges (1).
If there are not marked cutting edges (1), place removed carpet
over new piece and carry cuts over to new carpet.
Installation:
Apertures (3) serve as alignment points for fitting the carpet (2).
Replacement from build date 03/2007:
Depending on transmission variant, cut out apertures (1) for
shifting gate.
Use removed carpet as reference for trimming new carpet.
If necessary, refit apertures which have been cut out too much
after fitting (sound insulation).
RA Removing and installing / replacing front carpet for passenger compartment
BMW AG - TIS
18.02.2013 12:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
