5 Series E61 525xi (N52) TOUR
61 62 090
Removing and installing/replacing shaft
bearing for rear window wiper (Touring)
Necessary preliminary tasks:
•
Remove rear window wiper arm
•
Remove trim on shaft bearing
Secure rear window button (2) against falling down.
Release nut (1) and remove sealing ring underneath.
Important!
Risk of water ingress. Always replaced micro-coated nut (1) and
associated sealing ring. New sealing ring must not show any signs
of damage.
Tightening torque 61 62 7AZ
.
Release nut (1) and withdraw shaft bearing (2).
Installation:
Tighten nut (1) to specified torque, tightening torque 61 62 1AZ
.
RA Removing and installing/replacing shaft bearing for rear window wiper (Touring)
BMW AG - TIS
18.02.2013 16:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
