5 Series E61 525xi (N53) TOUR
Disconnect plug connection for oxygen monitor sensor and unclip
cable from holder.
Release monitor sensor (1) with special tools 11 7 030 and
11 9 150 .
Tightening torque: 11 78 1AZ
.
Installation:
Cable colour black, cylinders 1 to 3.
Note:
Release insulation (2) in direction of arrow.
Disconnect plug connection for oxygen monitor sensor.
Release monitor sensor (1) with special tool 11 7 020 .
Tightening torque: 11 78 1AZ
.
Installation:
Cable colour grey, cylinders 4 to 6.
Pay attention to cable routing of oxygen monitor sensor.
Assemble engine.
Check function of DME.
RA Removing and installing/replacing both lambda oxygen monitor sensors (N53)
BMW AG - TIS
17.02.2013 19:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -