5 Series E61 530d (M57T2) TOUR
Insert all screws (1) and initially tighten so that they are free of
play.
Tighten down camshaft bearing caps in 1/2 turn increments evenly
from inside to outside.
Screw special tool 11 6 254 onto cylinder head.
Note:
See illustration.
Check inlet camshaft axial clearance.
Set up special tool 11 6 250 with dial gauge.
Refer to Technical Data.
Adjust valve timing.
Assemble engine.
RA Replacing camshafts (M57T2)
BMW AG - TIS
18.02.2013 01:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
