5 Series E61 530d (M57T2) TOUR
Open drain plug (1) on engine block.
Installation:
Replace seal.
Tightening torque 11 11 5AZ
.
Open vent screw (1).
Use only recommended coolant, refer to BMW Service Operating
Fluids MG17.
Note:
Adhere to the following work sequence when adding coolant.
-
Switch ignition on
-
Seat heating to maximum temperature and fan to low speed
(heater valves are opened and auxiliary water pump starts
up).
-
Slowly fill expansion tank with coolant.
-
Close vent screw after bubble-free coolant emerges or after
filling up to max. cold fill level.
Vent cooling system.
RA Draining and adding coolant (M57T2)
BMW AG - TIS
18.02.2013 03:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -