5 Series E61 530xi (N52K) TOUR
21 51 500
Removing and installing or replacing clutch
release bearing/lever
Note:
(transmission removed)
New version (except M models)
Release bearing and release lever have been combined to form a
single release module.
If possible, do not disassemble the release module. Otherwise
there is a risk of the release module being incorrectly
reassembled.
Installation:
Make sure that the correct cam (1) of the release bearing is on the
sliding surface (2) of the release lever.
Fig. A: Cam (1) of release bearing (A=12 mm) is on sliding
surface of release lever.
This version is for 4-cylinder petrol/gasoline engines.
Fig. B: Cam (1) of release bearing (A=7 mm) is on sliding
surface of release lever.
This version is for 6-cylinder petrol/gasoline and diesel engines.
RA Removing and installing or replacing clutch release bearing/lever
BMW AG - TIS
18.02.2013 15:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -