5 Series E61 530xi (N52K) TOUR
Installation:
Release aluminium screw on right next to cable retaining plate
with special tool 00 9 010 .
Aluminium screws must be replaced. Tightening torque
24 00 2AZ
.
Release screws (1).
Take off holder (2).
Note:
Version 1:
Move selector lever to parking position "P".
Release screw (1).
Tightening torque: 25 16 2AZ
Remove clamp (2).
Release shift cable head (3) using a screwdriver from ball head
of shift cable lever.
Installation:
Adjust selector lever.
Note:
Version 2
Unfasten nut.
Disconnect cable (1)
Installation:
Unfasten nut.
Adjust cable by means of holder (2) until spacing A = 1 mm is
obtained.
Tighten nut.
RA Removing and installing automatic transmission (6HP19Z AWD) N52/N52K/N53
BMW AG - TIS
18.02.2013 15:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -