5 Series E61 530xi (N52K) TOUR
34 52 535
Replacing a rear pulse generator
Necessary preliminary tasks:
•
Remove rear wheel.
•
Read and comply with General Information.
Open connector housing (1), pull plug connector (2) out of bracket
and disconnect.
Pull cable out of brackets on swinging arm.
Installation:
Ensure proper locking of the plug connector and proper
seating of the cable in the brackets.
Release hexagon socket head cap screw (1) and pull wheel
speed sensor out of bore.
Installation:
Tightening torque, 34 51 6AZ
.
Clean bore hole for pulse generator and grease with
Staburags NBU 12/K lubricating grease (refer to BMW
Service Operating Fluids).
RA Replacing a rear pulse generator
BMW AG - TIS
18.02.2013 19:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -