5 Series E61 530xi (N52K) TOUR
Mark severance cuts in accordance with specified measurements and cut.
Important!
Cut outer plate only for following severance cuts.
Measurement a = approx. 40 mm in front of bore dia. 6 mm.
Measurement b = approx. 90 mm behind bore dia. 6 mm.
Measurement c = approx. 460 mm above upper door hinge mounting.
Measurement d = approx. 80 mm above cut c.
Open weld joints on outer entrance attachment (1) before and after severance cuts and remove components.
Open weld joints in areas (1) and (3).
Remove metal section (2).
Installation:
Apply repair welding spots in area (3) to existing welding spots on new component/car. This is necessary
because the adhesive between the spot flanges acts as an insulator.
RA Replacing cover for longitudinal member with left or right door pillar (partial
BMW AG - TIS
18.02.2013 20:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -