5 Series E61 530xi (N52K) TOUR
Press ejector (1) into bump stop and, in this position, twist approx.
90
°
counterclockwise with a Phillips screwdriver.
This locks the ejectors (1) in the bump stops.
Adjust bump stop (2) to correct height by turning left or right.
Unlock the ejector (1) again after completing adjustment.
Version 3:
Replace damaged bump stops (refer to EPC):
-
(1) Bump stop
Turn lock (1) 45
°
counterclockwise.
Pull bump stop (2) upwards.
Close lid slowly until it is at the same height as the side panel.
Open lid and turn lock (1) clockwise.
Installation:
Press bump stop into panel and drive in expanding pins (3).
RA Adjusting/replacing bump stops
BMW AG - TIS
18.02.2013 22:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -