5 Series E61 530xi (N52K) TOUR
51 24 151
Removing and installing/replacing hydraulic
cylinder for rear lid (electrohydraulic/fully
automatic)
Necessary preliminary tasks:
•
Disconnect hydraulic lines on hydraulic unit
•
Remove roofliner
•
Remove rear speaker on left side
Important!
Follow instructions for automatic rear lid actuation
(electrohydraulic)
The hydraulic unit may no longer be activated when the
hydraulic cylinder is removed (cylinder extended).
Lift hydraulic cylinder (1) in direction of arrow out of ball pin (2).
Repeat procedure on rear lid.
Important!
Check tightening torque of ball pin (2).
If ball pin (2) is loose, insert with Loctite 270 and screw
down.
Tightening torque 51 24 10AZ
.
Seal screw connection with wax.
Disconnect plug connection (1) through opening of left rear
speaker.
RA Removing and installing/replacing hydraulic cylinder for rear lid (electrohydrau
BMW AG - TIS
18.02.2013 22:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -