5 Series E61 530xi (N52K) TOUR
54 13 003
Adjusting glass slide/tilt sunroof lid
Special tools required:
•
00 9 315
•
00 9 340
Necessary preliminary tasks:
•
Remove gaiter on left and right
•
Close glass slide/tilt sunroof completely
If the glass slide/tilt sunroof is outside the adjustment tolerances,
adjust as follows:
Adjusting glass slide/tilt sunroof unit:
Carry out the following step on one side first and then the other
(first left, then right or vice versa):
•
Insert Torx screws (1) on left/right so that glass roof panel
can still just be adjusted
•
Move glass slide/tilt sunroof lid as required
•
Make sure all screws are tightened down.
•
Tightening torque 54 12 01AZ
.
•
Repeat procedure on other side.
Distance setting:
Distance A between body and glass lid (without seal):
A= 5.8
±
0.3 mm all round
Check same gap of glass lid and body with special tool
00 9 340 .
Slide special tool 00 9 340 or similar between seal and insert. It
must be possible to slide the card against the same level of
resistance.
Slide glass lid towards front or rear until ideal position is reached.
RA Adjusting glass slide/tilt sunroof lid
BMW AG - TIS
19.02.2013 08:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -