5 Series E61 535xi (N54) TOUR
Release screw.
Tightening torque 17 21 1AZ
.
Detach oil line from oil filter control housing.
Catch and dispose of emerging fluid.
Release bolt (1).
Tightening torque 17 21 2AZ
.
Disconnect oil line (2) from engine oil cooler flange and remove.
Catch and dispose of emerging fluid.
Important!
When tightening down the bolt, use suitable
means/equipment to prevent the flange from twisting.
.
Installation:
Replace all sealing rings on oil line.
Note:
After completing work, check engine oil level and top up if
necessary.
RA Removing and installing/replacing oil line for engine oil cooler (N54)
BMW AG - TIS
19.02.2013 08:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -