Removing and Replacing Floating Roofliners for Glass Slide Tilt
Rear floating roofliner:
Close roofliner completely but not in fan position.
Release screws (1).
Remove tensioning springs (left side only) and washers.
Slide floating roofliner (4) in direction of arrow (1) between outer
body skin and roofliner.
Slide floating roofliner (4) up to end of control rail (3).
Raise floating roofliner (4) and remove over control rail (3) in
direction of arrow (2).
Installation:
Tensioning springs (1) must rest correctly in recess of floating roofliner (2).
Adjust gap A = 3
±
0.2
mm from control rail (3) to floating roofliner (2).
RA Removing and installing/replacing both floating roofliners for glass slide/tilt
BMW AG - TIS
19.02.2013 18:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
