5 Series E61 545i (N62) TOUR
Replace sealing ring on tube (4) and coat with antiseize agent.
Removal:
Removal of cylinder head is described separately from installation.
Remove inlet and exhaust adjustment unit on left side.
Rotate eccentric shaft at dihedral head as illustrated in order to
reduce tension on torsion spring (1).
Pretension torsion spring (1) with a cable strap (2), feed out
from roller (3) and carefully relieve tension.
Rotate eccentric shaft at dihedral head as shown in illustration
back to minimum stroke position.
Note:
Spring mount (1) has a locating pin opposite screw.
Release screw.
Feed spring mount (1) upwards out of locating pin.
RA Removing and installing left cylinder head (N62 to 9/03)
BMW AG - TIS
19.02.2013 14:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
