5 Series E61 545i (N62) TOUR
32 41 ...
Replacing return line for power steering with
Dynamic Drive (N62, N62TU)
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Lower front axle support
Release nut (1) and remove pressure line (2) with round rubber
mount from holder.
Unscrew bolt (3).
Release quick-connect coupling (4) and seal valve block return
line with a suitable plug.
Installation:
Replace self-locking nut.
Make sure hydraulic line is laid without tension and with sufficient
spacing to adjoining components.
RA Replacing return line for power steering with Dynamic Drive (N62, N62TU)
BMW AG - TIS
19.02.2013 19:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
