6 Series 630i (N52) Coupe
41 00 ...
Bonding aluminium parts
Important!
Conform with safety precautions!
.
Overview of topics:
1.
Equipment
2.
Best before date of consumables
3.
Grinding and cleaning
4.
Flame-coating
5.
Primer coat
6.
Gluing coat
7.
Hardening times
8.
Disposing of adhesive
.
1.0 Equipment
-
Emery paper
-
Cleaning agent: Isopropanol, acetone or spirit
-
Brush, cotton wadding or similar
-
Adhesive cartridge (sourcing reference via BMW Parts Service picture board 83-0371 Aluminium and
steel/bonding and welding)
-
Primer
-
Flame coating set (refer to Service Information 5 03 03 975)
-
Spatula for applying adhesive
2.0 Best before date of consumables:
-
The adhesive cartridge, primer and special gas cartridge are all marked with a date.
-
Do not use the adhesive, primer and special gas cartridge after this date.
3.0 Grinding and cleaning:
-
For better adhesion, remove oxide film and paint from the adhesive areas with a stainless steel wire brush or
special emery paper.
-
Clean adhesive areas with isopropanol, acetone or spirit.
-
Allow cleaned surfaces to dry for approx. 5 minutes.
Adhesive areas must be completely dry.
-
The ridges on the repair parts (clamping pieces) approx. 0.5 mm high serve to orientate the minimum adhesive
RA Bonding aluminium parts
BMW AG - TIS
15.01.2013 16:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -