6 Series 630i (N52) Coupe
51 12 156
Removing and installing rear bumper trim
Special tools required:
•
00 9 317
Necessary preliminary tasks:
•
Partially remove luggage compartment wheel arch trim on left
.
•
Remove license plate.
Note:
The operation is described on the left side; proceed in the same
way for the right side.
Disconnect plug connection (1) and feed out wiring harness with
cable grommet (2) in direction of arrow.
Release short and long screws (1) and (2) on wheel arch
cover (3).
RA Removing and installing rear bumper trim
BMW AG - TIS
15.01.2013 17:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -