6 Series 630i (N52K) Coupe
Note:
Oil spray nozzle must be removed from 3rd cylinder (make a note
of installation position of oil spray nozzle).
Secure special tool 11 4 270 with gripping pliers (3) to guide
block (2).
Important!
Special tool 11 4 270 is only secured to guide block (2).
Adjusting the gripping pliers (3) on special tool 11 4 270 is
not permitted. Risk of damage!
Warning!
Risk of injury in event of incorrect use.
Important!
Improper handling. Risk of damage!
Secure both bearing pins (2) in torsion springs with knurled
screw (1) of special tool 11 4 270 .
Press special tool 11 4 270 in direction of arrow as far as it will
go.
Release screw (2) of torsion spring.
Tightening torque 11 37 2AZ
.
To avoid jamming of screw (2) with torsion spring, it is necessary
when releasing screw (2) to relieve the pretension on special
tool 11 4 270 uniformly.
Important!
Thread on cylinder head. Risk of damage!
Relieve tension on torsion spring (1) with special tool 11 4 270 .
Note:
Metal lug (2) cannot be disassembled and must not be removed.
Installation:
Replace torsion spring (1) if metal lug (2) is faulty.
RA Removing and installing/replacing intermediate levers (N52K)
BMW AG - TIS
16.01.2013 13:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -