6 Series 630i (N52K) Coupe
12 14 523
Replacing inlet camshaft pulse generator
(N52, N52K, N51, N53)
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
If necessary, remove radiator cover
Unlock plug (1) and remove.
Release bolt.
Installation:
Replace screw.
Tightening torque 12 14 3AZ
.
Remove pulse generator (2).
Note:
Check stored fault messages.
Now clear the fault memory.
RA Replacing inlet camshaft pulse generator (N52, N52K, N51, N53)
BMW AG - TIS
16.01.2013 14:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -