6 Series 630i (N52K) Coupe
E65 only:
Press release tabs (1) and pull slide (2) in direction of arrow out
of housing.
E65 only:
Press release tabs (1) in direction of arrow and pull contact
carrier (2) in direction of arrow out of housing.
Unlock and disconnect all plug connections of engine wiring
harness section in electronics box.
Release screws and remove holder (1).
Tightening torque 12 52 1AZ
.
Work step
Note:
Unlock plug connections on control sensors and disconnect
Unlock plug on alternator and disconnect
Unlock plug connection on knock sensors and disconnect
Unlock plug on crankshaft sensor and disconnect
Unlock plug on starter motor and disconnect
Remove rear underbody protection
Unlock plug connections on monitor sensors and disconnect
Unlock plug on oil condition sensor and disconnect
RA Replacing wiring harness section for engine (N52)
BMW AG - TIS
16.01.2013 14:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -