6 Series 630i (N52K) Coupe
31 10 000
Removing and installing complete front axle
(with spring strut shock absorber)
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Draw off and dispose off hydraulic fluid from fluid reservoir
•
Secure engine in installation position
•
Remove front wheels
•
Disconnect plug connection of both pulse generators
•
Remove both brake calipers from swivel bearing and tie up
•
Remove reinforcement plate
•
If necessary, remove steering gear cover on both sides
•
Remove wheel suspension cover on both sides
•
Remove lower steering spindle from power steering gear
•
If necessary, disconnect plug connection on EH converter
and expose line up to engine carrier
•
If necessary, disconnect plug connection on ride-height
sensor and expose line up to engine carrier
•
If necessary, expose and disconnect vacuum line for engine
mount up to point of separation on engine support arm
•
Except M5, M6: Disconnect pressure line(s) from vane pump
•
M5, M6: Disconnect pressure line from power steering gear
•
Disconnect return line from power steering cooler
•
Remove both stabilizer links from spring strut bracket
RA Removing and installing complete front axle (with spring strut shock absorber)
BMW AG - TIS
16.01.2013 15:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -