6 Series 630i (N52K) Coupe
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
•
Carry out steering angle sensor adjustment/adjustment for
active steering
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing complete front axle (with spring strut shock absorber)
BMW AG - TIS
16.01.2013 15:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -