6 Series 630i (N52K) Coupe
31 12 000
Removing and installing/replacing left or right
control arm
Note:
If the control arm is detached from the front axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
If necessary, remove steering gear cover at side
Right side only on version with xenon headlight:
Release nut (jointed rod on control arm).
Remove jointed rod (1) from control arm.
Disconnect plug connection (2) on ride-height sensor.
Unscrew nut (1).
Remove screw towards rear.
Only on right side: If necessary, remove holder with ride-height
sensor.
Installation:
Replace self-locking nut.
Tightening torque 31 12 2AZ
.
Release nut (2); if necessary, grip at Torx socket.
RA Removing and installing/replacing left or right control arm
BMW AG - TIS
16.01.2013 15:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -