6 Series 630i (N52K) Coupe
If necessary, remove protective cap.
Knock out centering pin (1) in downwards direction.
Clean wheel arch from below in area of support bearing with
compressed air.
Slacken nut (2) approx. 1 to 1.5 turns.
Insert special tool 32 3 190 into wheel arch opening and over
nut.
Replace nuts (3) and screw on but do not tighten down fully.
Adjusting procedures:
1.
Turn nut (4) in special tool 32 3 190 to adjust camber to
specified value.
2.
Check cumulative steering angle; if necessary, set to "zero"
3.
Check camber values; if necessary, repeat adjustment
procedure
Tighten down nuts (3)
Tightening torque 31 31 1AZ
.
Remove special tool 32 3 190 .
Replace nut (2) and tighten down.
Tightening torque 31 31 1AZ
.
After installation:
•
Check directional stability of car; if necessary, repeat toe-in
adjustment
•
Version with active front steering: Remove special tool
32 4 150 .
RA Adjusting toe-in and camber on front axle
BMW AG - TIS
16.01.2013 16:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -