6 Series 630i (N52K) Coupe
33 32 091
Replacing a guide arm
Important!
The guide arm to wheel carrier connection has been changed
from a conical seat to a ball seat! Spare parts are offered for
both variants.
To ensure a correct bolt connection, check before installing
the guide arm whether the seat for the guide arm matches the
seat for the wheel carrier.
For reasons of driving dynamics, the guide arms may only be
replaced in pairs!
Variants:
A) M10 journal: Conical seat
B) M12 journal: Ball seat
Note:
If the guide arm is detached from the rear axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove rear wheel.
RA Replacing a guide arm
BMW AG - TIS
16.01.2013 16:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -