6 Series 630i (N52K) Coupe
34 52 575
Removing and installing/replacing front
pressure sensor for ACC
Necessary preliminary tasks:
•
Remove front right wheel arch trim
•
Read and comply with General Information.
After completing work: Bleed braking system
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
Unfasten plug connection (1).
Release pressure sensor (2) and remove.
Installation:
Tightening torque 34 51 12AZ
.
RA Removing and installing/replacing front pressure sensor for ACC
BMW AG - TIS
16.01.2013 17:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -