6 Series 630i (N52K) Coupe
51 11 156
Removing and installing front bumper trim
Important!
Risk of mixing up
Different screws fitted.
Raise bonnet/hood.
Release screws (1) on bumper trim (2).
Note:
The operation is described on the left side; proceed in the same
way for the right side.
Lever out trim (1 and 2) in direction of arrow.
Installation:
Make sure trims (2) are in correct installation position.
Installation:
Catches (1) on trim (2) must not be damaged.
RA Removing and installing front bumper trim
BMW AG - TIS
16.01.2013 18:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -