6 Series 630i (N52K) Coupe
Release screws (1).
Installation:
Make sure flaps (2) are correctly seated in mountings (3).
Release screws (1).
Remove upper housing section (2) in direction of arrow.
Installation:
Make sure upper housing section (2) is correctly seated on lower
housing section.
Make sure flaps (3) are correctly seated in mountings (4).
Release screws (1).
Release clip (2).
Remove cover (3) in direction of arrow.
Installation:
Make sure cover (3) is correctly seated.
Important!
Do not bend radiator fins.
If necessary, clean or straighten radiator fins with slat comb.
RA Removing and installing/replacing evaporator
BMW AG - TIS
16.01.2013 23:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -