6 Series 630i (N52K) Coupe
86 21 ...
Removing centering pin from mounting
bracket
Note:
Exclusively for removal of pin, raise the hood in the GFP area.
For raising, use a wooden block with a maximum width of
35 mm and a height of 45 mm. The length must be selected
depending on the lifting platform securing point. Ensure the
hood is secure on the blocks.
Position block (1) so that it is only located in area of sponge
rubber seal (2).
Insert a mandrel into hole (1) of pin (2) and turn
counterclockwise.
RA Removing centering pin from mounting bracket
BMW AG - TIS
17.01.2013 00:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -