6 Series 630i (N53) Coupe
Release screws (1, 2).
Installation:
Check threads for damage; if necessary, repair with Helicoil
thread inserts.
Tighten down screws (1) and then screws (2).
Tightening torque 31 10 1AZ
.
Lower front axle carrier.
Note:
If necessary, perform the following work steps if the front axle
carrier has to be lowered by more than 10 cm.
Version with Dynamic Drive:
Detach pressure lines from oscillating motor of front axle.
Release screw.
Tightening torque 37 14 14AZ
.
Move pipe holder towards rear.
After installation:
•
Version with Dynamic Drive:
-
Fill and bleed hydraulic system
-
Check pipe connections for leaks
•
Carry out steering angle sensor adjustment/adjustment for
active steering
•
Carry out initial Dynamic Drive operation
RA Lowering/raising front axle carrier
BMW AG - TIS
17.01.2013 14:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
