6 Series 630i (N53) Coupe
51 47 315
Removing and installing / replacing front
carpet for passenger compartment
Necessary preliminary tasks:
•
Remove both front seats
•
Remove storage compartment
•
Remove side trim in footwell
•
Remove glovebox
•
Remove trim panel for pedal assembly
•
Remove accelerator pedal module
Cut out carpet (1) at marked cutting edges (2) on left and right.
Important!
If there are no marked cutting edges (2), align cuts as far as
possible in direction of middle of vehicle. This ensures that the
cutting edges are covered by the storage
compartment/instrument panel.
Pay attention to cables when cutting (risk of damage).
If necessary, guide cable back through carpet (1).
Feed out carpet (1) towards rear/top.
Note:
Marked cutting edges (1) shown on removed carpet (2).
Replacement:
Cut out carpet at marked cutting edges (1).
If there are not marked cutting edges (1), place removed carpet
over new piece and carry cuts over to new carpet.
Installation:
Apertures (3) serve as alignment points for fitting the carpet (2).
Replacement:
If necessary, remove stowage net.
RA Removing and installing / replacing front carpet for passenger compartment
BMW AG - TIS
17.01.2013 17:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
